Planet WGSW-20160HP - Ip Igmp Snooping Query-Interval

Command Guide
-179-
Default:
Enabled
Usage Guide:
To enable Querier-election of IGMP snooping for specific VLAN
Example:
To enable Querier-election of IGMP snooping for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip igmp snooping querier election
4.2.66.14 ip igmp snooping query-interval
Command:
ip igmp snooping query-interval <IpmcQi : 1-31744>
ip Interface Internet Protocol config commands
igmp Internet Group Management Protocol
snooping Snooping IGMP
query-interval Query Interval in seconds
<IpmcQi : 1-31744> 1 - 31744 seconds
Default:
125
Usage Guide:
To configure Querier-interval of IGMP snooping for specific VLAN
Example:
To configure Querier-interval (600 seconds) of IGMP snooping for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip igmp snooping query-interval 600