Planet WGSW-20160HP - Access-List Rate-Limiter; Access-List Rate-Limiter Pps

Command Guide
-63-
4.2.16 access-list rate-limiter
Command:
access-list rate-limiter <RateLimiterList : 1~16> pps <PpsRate : 0-131071>
<RateLimiterList : 1~16> Rate limiter ID
<PpsRate : 0-131071> Rate value
Default:
0
Usage Guide:
To set pps rate for specific rate-limiter ID.
Example:
To set pps rate(10000 pps) for specific rate-limiter ID 1.
Switch# configure terminal
Switch (config)# access-list rate-limiter 1 pps 10000
4.2.17 access-list rate-limiter pps
Command:
access-list rate-limiter pps <PpsRate : 0-131071>
<PpsRate : 0-131071> Rate value
Default:
0
Usage Guide:
To set pps rate for all rate-limiter ID.
Example:
To set pps rate(10000 pps) for all rate-limiter ID.
Switch# configure terminal
Switch (config)# access-list rate-limiter pps 100