Planet WGSW-20160HP - Ntp

Command Guide
-267-
Switch# configure terminal
Switch (config)# network-clock clk-source 1 aneg-mode slave
4.2.165 no
Command:
no
no Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function
Example:
To disable the function (loop-protect)
Switch# configure terminal
Switch (config)# no loop-protect
4.2.166 ntp
Command:
ntp
ntp Configure NTP
Default:
Disabled
Usage Guide:
To enable the NTP service
Example:
To enable the NTP service
Switch# configure terminal
Switch (config)# ntp