Planet WGSW-20160HP - Ip Igmp Ssm-Range

Command Guide
-207-
Default:
Disabled
Usage Guide:
To enable IGMP Snooping for specific VLAN.
Example:
To enable IGMP Snooping for VLAN 1.
Switch# configure terminal
Switch (config)# ip igmp snooping vlan 1
4.2.82 ip igmp ssm-range
Command:
ip igmp ssm-range <ipv4_mcast> <Ipv4PrefixLength : 4-32>
ip Internet Protocol
igmp Internet Group Management Protocol
ssm-range IPv4 address range of Source Specific Multicast
<ipv4_mcast> Valid IPv4 multicast address
<vlan_list> VLAN identifier(s): VID
<Ipv4PrefixLength : 4-32> Prefix length ranges from 4 to 32
Default:
232.0.0.0/8
Usage Guide:
To enable SSM Range of IGMP.
Example:
To enable SSM Range (239.239.239.239/32) of IGMP.
Switch# configure terminal
Switch (config)# ip igmp ssm-range 239.239.239.239 32