5
5.7
15.With the belt removed, completely remove the
retaining bolt and driven clutch
r
.
16.Install the Drive Clutch Holder (PN 9314177-A) onto
the drive clutch.
Drive Clutch Holder:
9314177-A
17.Remove the drive clutch retaining bolt
t
by turning
the bolt in a clockwise direction.
NOTE
The drive clutch retaining bolt has left-hand threads.
Turn the bolt clockwise to remove it.
18.Insert the Drive Clutch Puller (PA-48595) into the
drive clutch and use it to remove the clutch from the
shaft.
Drive Clutch Puller:
PA-48595
19.If removing the inner PVT cover, continue with this
procedure.
a. Remove the (10) screws that retain the inner PVT
cover to the transmission case and remove the
cover.
b. Remove the old silicone material from the inner
PVT cover and transmission case using a wire
brush. Clean both surfaces thoroughly in
preparation for assembly.
PVT SYSTEM
To Next Page
Loading...
