Turn Off Flashing Alerts
You can turn off flashing alerts when the visual cue is not necessary in the RealPresence Group Series
system web interface.
Procedure
1. In the system web interface, go to Admin Settings > General Settings > System Settings > Call
Settings.
2. Clear the Enable Flashing Incoming Call Notification checkbox.
3. Click Save.
Setting Up Audio-Only Calls
You can enable and disable audio-only calls in the RealPresence Group Series system web interface.
Enable Audio-Only Calls
You can enable audio-only calls in the RealPresence Group Series system web interface.
Procedure
1. In the system web interface, go to Admin Settings > Network > Dialing Preference > Dialing
Options > and select Enable Audio-Only Calls.
2. Click Save.
Disable Audio-Only Calls
You can disable audio-only calls in the RealPresence Group Series system web interface.
Procedure
1. In the system web interface, go to Admin Settings > Network > Dialing Preference > Dialing
Options and clear the Enable Audio-Only Calls checkbox.
2. Click Save.
Select the Call Type Order for Audio-Only Calls
When Audio-Only Calls is enabled on your RealPresence Group Series system, you can choose the
audio order and dialing preference.
Procedure
1. In the system web interface, go to Admin Settings > Network > Dialing Preference > Dialing
Options.
2. At Call Type Order, select Phone then Video.
3. For the Audio Dial Preference 1, Audio Dial Preference 2, and Audio Dial Preference 3
settings, choose from the following call types:
• IP H.323
• SIP
Configuring Call Settings
Polycom, Inc. 128
To Next Page
Loading...
Need help?
General
