Setting Description
Default Gateway Displays the gateway currently assigned to the system.
If the system does not automatically obtain a gateway
IP address, enter one here.
Configure IP Address (IPv6) Settings
You can configure IP address (IPv6) settings for RealPresence Group Series systems.
Procedure
1. In the system web interface, go to Admin Settings > Network > LAN Properties.
2. Configure the following IPv6 settings on the LAN Properties screen.
Setting Description
Enable IPv6 Enables the IPv6 network stack and makes the IPv6
settings available.
IP Address Specifies how the system obtains an IP address.
• Obtain IP address automatically—Select if the
system gets an IP address from a SLAAC or a
DHCP server on the LAN.
• Enter IP address manually—Select if the IP
address will not be assigned automatically.
Enable SLAAC Specifies whether to use stateless address
autoconfiguration (SLAAC) instead of DHCP to
automatically obtain an IP address.
Using DHCP to get the IP address requires a DHCP
server to get the address from the network, but with
SLAAC, existing routers help the system get the IP
address from the network.
Link-Local Displays the IPv6 address used for local
communication within a subnet.
This setting is configurable only when Enter IP
Address Manually is selected.
Site-Local Displays the IPv6 address used for communication
within the site or organization.
This setting is configurable only when Enter IP
Address Manually is selected.
Global Address Displays the IPv6 internet address.
This setting is configurable only when Enter IP
Address Manually is selected.
Configuring Network Settings
Polycom, Inc. 62
To Next Page
Loading...
Need help?
General
