B01AMNOMAT*1111000010
Enable NOM attenuation
on outputs 1-4 and T,
and disable NOM
attenuation on outputs
A-D and L.
B01AMNOMAT*1111000010
B01AMNOMAT*2
Toggle status of NOM
attenuation on all
outputs.
B01AMNOMAT*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current status of NOM attenuation on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01AMNOMAT*0000111101 .
B01AMNOMAT*?
Query NOM attenuation
status of all outputs.
B01AMNOMAT*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current status of the NOM attenuation on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01AMNOMAT*0000111101 .
8.26. AMOFFAT -- Set Off Attenuation for the Specified
Automixer
This command sets the off attenuation (in dB) for the specified automixer. Setting this value to 18 would
result in the microphone signals being attenuated by 18 dB when gated off. This value is set independently
for each of the automixers. The first argument of this command specifies the automixer number (1-2) to
adjust. The second argument specifies the off attenuation.
Even though this is a channel integer command, use of the wildcard for specifying the automixer number is
not supported.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are 1 and 100, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AMOFFAT118
Set off attenuation for automixer 1 to
18 dB.
B01AMOFFAT118
B01AMOFFAT2?
Query current off attenuation for
automixer 2 .
B01AMOFFAT2x , where x is between 1 and 100
depending on the current setting of the off
attenuation for automixer 2 .
8.27. AMPRIOR -- Set Gating Priority for the Specified Mic
This command sets the automixer gating priority for the specified input channel. Priority levels of 1-4 are
allowed with 1 being the highest priority and 4 being the lowest.
To Next Page
Loading...
Need help?
General
