Polycom Vortex EF2241 - GAIND - Set Gain of Incoming DTMF Tones; GAINDIT - Set Gain of Incoming DTMF Tones

B01GAINA?
Query phone input gain.
B01GAINAx , where x is the new value of the phone
input gain. If this command was issued after the
example above, then the status message would be
B01GAINA9 .
8.55. GAIND -- Set Gain of Incoming DTMF Tones
This command sets the gain of the incoming DTMF tones. The gain of the outgoing DTMF depends on the
country that the Vortex is configured for (see the
COUNTRY) command. This command is an alias for the
GAINDIT command. It is provided for backwards compatibility with and ease of migration from the EF200.
When possible, the
GAINDIT command should be used instead of this command.
This command is an integer command. See
Section 6.2 for more information on this type of command. The
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01GAIND6
Set incoming DTMF gain to 6 dB.
B01GAIND6
B01GAIND>3
Increase incoming DTMF gain by 3 dB.
B01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was issued
after the example above, then the status message
would be B01GAIND9 .
B01GAIND?
Query incoming DTMF gain.
B01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was issued
after the example above, then the status message
would be B01GAIND9 .
8.56. GAINDIT -- Set Gain of Incoming DTMF Tones
This command sets the gain of the incoming DTMF tones. The gain of the outgoing DTMF depends on the
country that the Vortex is configured for (see the COUNTRY) command.
This command is an integer command. See
Section 6.2 for more information on this type of command. The
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01GAINDIT6
Set incoming DTMF tone gain to 6 dB.
B01GAINDIT6
B01GAINDIT>3
Increase incoming DTMF tone gain by 3
dB.
B01GAINDITx , where x is the new value of
the incoming DTMF tone gain. If this command
was issued after the example above, then the
status message would be B01GAINDIT9 .