The first argument of this command specifies the automixer number (1-2) to adjust. The second argument
specifies the NOM limit (1-4) . Even though this is a channel integer command, use of the wildcard for
specifying the automixer number is not supported.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are 1 and 64, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AMNOM13
Set local NOM for automixer 1 to a maximum
of 3 mics.
B01AMNOM13
B01AMNOM2?
Query current local NOM limit for automixer
2 .
B01AMNOM2x , where x is between 1 and 4
depending on the current setting of the local
NOM limit for automixer 2.
8.25. AMNOMAT -- Select NOM Attenuation on Each Output
This command enables, disables, or queries NOM attenuation for the specified output (1-4, A-D, T, L) . .
NOM attenuation is calculated as 10*log(Number of Open Microphones).
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AMNOMAT41
Enable NOM attenuation
on output 4 .
B01AMNOMAT41
B01AMNOMATA0
Disable NOM
attenuation on output
A.
B01AMNOMATA0
B01AMNOMATL2
Toggle NOM attenuation
status on output L
(power amplifier) .
B01AMNOMATLx , where x is either 0 or 1
depending on the current mute status of NOM
attenuation on the ouptut.
B01AMNOMATB?
Query NOM attenuation
status of output B.
B01AMNOMATBx , where x is either 0 or 1
depending on the current NOM attenuation status of
the output.
B01AMNOMAT*1
Enable NOM attenuation
on all outputs (1-4, A-D,
T, L) .
B01AMNOMAT*1111111111
B01AMNOMAT*0
Disable NOM
attenuation on all
outputs (1-4, A-D, T, L)
.
B01AMNOMAT*0000000000
To Next Page
Loading...
