Example Description Status Message
B01MUTEGIL1
Mute all line inputs.
B01MUTEIA1
B01MUTEIB1
B01MUTEIC1
B01MUTEID1
B01MUTEGIL2
Toggle mute status of all line inputs.
B01MUTEIAa
B01MUTEIBb
B01MUTEICc
B01MUTEIDd ,
where a, b, c, and d reflect the mute status (0
or 1) of each of the line inputs. If this
command was issued after the example above,
then the status messages would be:
B01MUTEIA0
B01MUTEIB0
B01MUTEIC0
B01MUTEID0 .
B01MUTEGIL?
Query the mute status of all the line inputs.
B01MUTEIAa
B01MUTEIBb
B01MUTEICc
B01MUTEIDd ,
where a, b, c, and d reflect the mute status (0
or 1) of each of the line inputs. If this
command was issued after the example above,
then the status messages would be:
B01MUTEIA0
B01MUTEIB0
B01MUTEIC0
B01MUTEID0 .
8.110. MUTEGIM -- Set Mute Status of Microphone Inputs as a
Group
This command sets the mute status of all the microphone inputs simultaneously. This is different from using
a wildcard, * with the MUTEI command because that command sets all the mic and line inputs together,
while the MUTEGIM sets only the mic inputs.
This command will generate acknowledgements from each of the mic inputs separately.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
To Next Page
Loading...
Need help?
General
