EasyManuals Logo

Polycom Vortex EF2241 User Manual

Polycom Vortex EF2241
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
B01AEC*?
Query AEC state on input channels 1-4.
B01AEC*abcd, where a-d are each 0 or 1 depending
on the current state of the AEC for each of the four
input channels.
8.4. AECMODE -- Set Amount of Double Talk Suppression used
in the AEC.
This command sets the amount of double talk suppression used in the AEC on input channels 1-4 . The
values correspond to the following settings.
1 = No Suppression
2 = Light Suppression
3 = Heavy Suppression
4 = Half Duplex
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are 1 and 4, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AECMODE13
Set AEC on input channel 1 to
Heavy Suppression.
B01AECMODE13
B01AECMODE1?
Query AEC suppression level on
input channel 1.
B01AECMODE1x , where x is 1, 2, 3, or 4
depending on the current setting of the AEC
suppression level on input channel 1.
B01AECMODE*1
Set AEC on input channels 1-4
to No Suppression.
B01AECMODE*àààà
B01AECMODE*ààêê
Set AEC on input channels 1-2
to No Suppression and AEC on
input channels 3-4 to Half
Duplex.
B01AECMODE*ààêê
B01AECMODE*?
Query AEC suppression level on
input channels 1-4.
B01AECMODE*abcd, where a-d are each à, å, ç, or
ê depending on the the current setting of the AEC
suppression levels on input channels 1-4.
8.5. AGC -- Enable or Disable Mic/Line Input Automatic Gain
Control
This command sets or queries the status of the Automatic Gain Control (AGC) algorithm on input channels 1-
4 and T (the telephone input) .
When the wildcard character, '*', is used to specify the channel in this command, it only affects input
channels 1-4. To set or query the telephone input channel, T, you must specify it explicitly (e.g.,
'B01AGCT1', 'B01AGCT?').

Table of Contents

Other manuals for Polycom Vortex EF2241

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom Vortex EF2241 and is the answer not in the manual?

Polycom Vortex EF2241 Specifications

General IconGeneral
BrandPolycom
ModelVortex EF2241
CategoryTelephone Accessories
LanguageEnglish

Related product manuals