B01GAINGIL>3
Increase incoming gain on all line inputs
by 3 dB.
B01GAINIAa
B01GAINIBb
B01GAINICc
B01GAINIDd ,
where a, b, c, and d are the new values of
each of the line inputs. If this command was
issued after the example above, then the status
messages would be:
B01GAINIA10
B01GAINIB10
B01GAINIC10
B01GAINID10 .
B01GAINGIL?
Query gains on all line inputs.
B01GAINIAa
B01GAINIBb
B01GAINICc
B01GAINIDd ,
where a, b, c, and d are the new values of
each of the line inputs. If this command was
issued after the example above, then the status
messages would be:
B01GAINIA10
B01GAINIB10
B01GAINIC10
B01GAINID10 .
8.59. GAINGIM -- Set Gain of Microphone Inputs as a Group
This command sets the gains of all the microphone inputs simultaneously. This is different from using a
wildcard, * with the GAINI command because that command sets all the mic and line inputs together, while
the GAINGIM sets only the mic inputs.
This command will generate acknowledgements from each of the mic inputs separately.
This command is an integer command. See
Section 6.2 for more information on this type of command. The
minimum and maximum values for this command are 0 and 30, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01GAINGIM7
Set gain of all mic inputs to 7 dB.
B01GAINI17
B01GAINI27
B01GAINI37
B01GAINI47
To Next Page
Loading...
Need help?
General
