B01AMAUTO3?
Query AMAUTO state on input
channel 3 .
B01AMAUTO3x , where x is 0 or 1 depending on
whether input channel 3 is currently set for manual or
automatic thresholds.
B01AMAUTO*1
Select automatic thresholds for
automixer gating on input channels
1-4.
B01AMAUTO*1111
B01AMAUTO*0
Select manual thresholds for
automixer gating on input channels
1-4.
B01AMAUTO*0000
B01AMAUTO*2
Toggle between manual and
automatic thresholds for automixer
gating input channels 1-4.
B01AMAUTO*abcd, where a-d are each 0 or 1
depending on whether each input channel is currently
set for manual or automatic thresholds.
B01AMAUTO*?
Query AMAUTO state on input
channels 1-4.
B01AMAUTO*abcd, where a-d are each 0 or 1
depending on whether each input channel is currently
set for manual or automatic thresholds.
8.13. AMBUSID -- Set Automixer Groupings for EF Bus
This command is used to assign one of the two internal automixers to one of the EF Bus automixer groups.
For example, consider three EF2241's, each of which has two microphones assigned to Automixer 1 and two
microphones assigned to Automixer 2. Now, if each of these EF2241's sets their Automixer 1 to have Bus ID
5, then the three automixers (one from each EF2241) will work as a single automixer containing 6 (3 x 2)
microphones. Setting AMBUSID to 0 means that the specified automixer is not grouped on the bus.
The first argument in the AMBUSID command is the automixer number (1 or 2) and the second argument is
the Bus ID (0 for none, or 1 through 8). Although this command is a channel integer command, use of the
wildcard character for the automixer number is not supported.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are 0 and 8, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AMBUSID12
Configure Automixer 1 to be part of the
Bus Automixer having Bus ID 2.
B01AMBUSID12
B01AMBUSID20
Configure Automixer 2 to be part of the
Bus Automixer having Bus D 0. This
means that the automixer is not part of
any Bus Automixer.
B01AMBUSID20
B01AMBUSID1?
Query the current Bus ID of Automixer
1 .
B01AMBUSID1x , where x is a number between
0 and 8 indicating the current Bus ID of
Automixer 1 .
8.14. AMCHAIR -- Enable Chairman Mode for Specified
Automixer
To Next Page
Loading...
