***PING
Ping all connected device to determine the number, type, and ID of the
connected devices.
F00PONG
F01PONG
B02PONG
B03PONG
S04PONG
S05PONG
Q06PONG
Q07PONG
T00PONG
T01PONG
8.135. PRESETK -- Delete One or All Presets
This command kills (deletes) the specified preset. If a wildcard character (*) is used to specify the preset,
then all presets are deleted.
If an attempt is made to delete one of the factory presets (in the range 0-15), the PRESETK command will
fail and generate an ERROR#071. This is because the factory presets are read-only, thus the cannot be
changed or deleted.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
time it is changed. It will retain its value after power-down. Since this command writes to non-volatile
memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
B01PRESETK18
Delete preset number 18.
B01PRESETK18
B01PRESETK*
Delete all presets.
B01PRESETK*
8.136. PRESETL -- List All Commmands in a Preset
This command lists all the commands in a given preset. For example, assume that user preset 18 has been
defined previously by the following command.
B01PRESETW18
Now, issuing the command:
B01PRESETL18?
Will result in a long sequence of status mesages reflecting all the data stored in the preset. At the end of the
status messages, a final message of
B01PRESETL18
will be displayed.
To Next Page
Loading...
