B01DELAYOE*2
Toggle enabled status
of output delay on all
outputs.
B01DELAYOE*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01DELAYOE*0000111101 .
B01DELAYOE*?
Query enabled status of
output delay on all
outputs.
B01DELAYOE*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01DELAYOE*0000111101 .
8.43. DIAL -- Send DTMF Digits to Phone Interface
This command dials the specified string of digits by sending the equivalent DTMF tones to the phone
interface. Valid digits are '0'-'9', '*', '#', and ',' (delay). If the phone is not off-hook when this command is
executed, it will automatically be taken off-hook.
Example Description Status Message
B01DIAL9,,,4048921180
Dial 9 (to get an outside line), then pause (the three
commas), then dial 4048921180.
B10DIAL
8.44. DSPAUTO -- Enable Automatic DSPLOAD Status Messages
This command sets or queries whether or not DSPLOAD messages will be automatically generated whenever
the DSP utilization changes.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
Example Description Status Message
B01DSPAUTO1
Enable automatic DSPLOAD messages.
B01DSPAUTO1
B01DSPAUTO0
Disable automatic DSPLOAD messages.
B01DSPAUTO0
B01DSPAUTO2
Toggle automatic DSPLOAD messages.
B01DSPAUTOx , where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
B01DSPAUTO?
Query the value of the DSPAUTO
parameter.
B01DSPAUTOx , where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
8.45. DSPLOAD -- Query Percentage of Variable DSP Resources
Used
This command queries the current percentage used of the available variable DSP resources. When this
number reaches 100 percent, no more variable DSP veatures may ben enabled. An 'ERROR#060' will be
To Next Page
Loading...
