Polycom Vortex EF2241 User Manual

B01SOUNDP1
Play "descending thirds" sound (same as exit tone) to phone output.
B01SOUNDP1
8.150. SSDELAY -- Set Delay Between Screen Saver Screens
This command sets or queries the amount of time (in milliseconds) between each new screen of the LCD
screen saver.
This command is an integer command. See
Section 6.2 for more information on this type of command. The
minimum and maximum values for this command are 500 and 600000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01SSDELAY2000
Set screen saver delay to 2
seconds (2000 ms).
B01SSDELAY2000
B01SSDELAY>500
Increase screen saver delay by 0.5
seconds (500 ms).
B01SSDELAYx , where x is the new value of the
screen saver delay. If this command was issued
after the example above, then the status message
would be B01SSDELAY2500 .
B01SSDELAY?
Query screen saver delay.
B01SSDELAYx , where x is the new value of the
screen saver delay. If this command was issued
after the example above, then the status message
would be B01SSDELAY2500 .
8.151. SSEN -- Enable or Disable Screen Saver
This command controls whether or not the LCD screen saver is enabled.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01SSEN1
Enable screen saver.
B01SSEN1
B01SSEN0
Disable screen saver.
B01SSEN0
B01SSEN2
Toggle screen saver enabled state.
B01SSENx , where x is 0 or 1 depending on the current
enabled state of the scrren saver.
B01SSEN?
Query screen saver enabled state.
B01SSENx , where x is 0 or 1 depending on the current
enabled state of the scrren saver.
8.152. SSSTART -- Set Idle Time Required for Screen Saver to
Start

Polycom Vortex EF2241 Specifications

General

Brand	Polycom
Model	Vortex EF2241
Category	Telephone Accessories
Language	English