Polycom Vortex EF2241 User Manual

'B01AGCRATET10', 'B01AGCRATET?').
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are 1 and 5, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AGCRATE13
Set AGC ramp rate on input
channel 1 to 3 dB/sec.
B01AGCRATE13
B01AGCRATET?
Query the AGC ramp rate on
input channel T .
B01AGCRATETx where x is a number between 1
and 5, depending on the current setting of the AGC
ramp rate on input channel T .
B01AGCRATE*5
Set AGC ramp rate on input
channels 1-4 to 5 dB/sec.
B01AGCRATE*ëëëë
B01AGCRATE*ààêê
Set AGC ramp rate on input
channels 1-2 to 1 dB/sec and
AGC ramp rate on input
channels 3-4 to 4 dB/sec.
B01AGCRATE*ààêê
B01AGCRATE*?
Query AGC ramp rate on input
channels 1-4.
B01AGCRATE*abcd, where a-d are each between à
and ë, depending on the current setting of the AGC
ramp rate for each of the four input channels.
8.9. AHCP -- Enable or Disable Call Progress Based Auto
Hangup
This command sets or queries the status of the call progress based auto hangup feature. There are two
methods of auto hangup supported: call progress and loop drop. The call progress method listens for off-
hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for a drop in
loop current on the phone line and hangs up the phone if a loop current drop is detected. The AHCP
command controls the call progress auto hangup feature. The
AHLD command controls the loop drop auto
hangup feature. These two features are controlled and implemented independently.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01AHCP1
Enable call progress based auto hangup mode.
B01AHCP1
B01AHCP0
Disable call progress based auto hangup mode.
B01AHCP0
B01AHCP2
Toggle call progress based auto hangup mode.
B01AHCPx , where x is 0 or 1 depending on
the current state of the call progress based
auto hangup mode.

Polycom Vortex EF2241 Specifications

General

Brand	Polycom
Model	Vortex EF2241
Category	Telephone Accessories
Language	English