EasyManuals Logo

Polycom Vortex EF2241 User Manual

Polycom Vortex EF2241
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
is an additional gain stage, referred to as a fader. The fader gain is adjustable by the FADERI command. The
GAINI setting should be used for calilbration in order to maximize the resolution and quality of the signal at
the analog to digital converter. The FADERI command is provided as a way to do volume control on the
inputs without affecting the calibration.
This command also adjusts the fader gain of the input signal coming from the telephone interface.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on this
type of command. The minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01FADERIT10
Set fader gain on input T
to 10 dB.
B01FADERIT10
B01FADERIT?
Query the fader gain on
input T .
B01FADERITx , where x is a number between 0 and
30, depending on the current setting of the fader
gain on input channel T .
B01FADERI*6
Set fader gain on all
inputs (1-4, A-D, T) to 6
dB.
B01FADERI*èèèèèèèèè
B01FADERI*ääääììììä
Set fader gain on input
channels 1-4 and T to 0
dB and gain on input
channels A-D to 9 dB.
B01FADERI*ääääììììä
B01FADERI*?
Query fader gain on all
inputs (1-4, A-D, T) .
B01FADERI*abcdefghi, where a-i are each
between ä and ÿ, depending on the current setting
of the fader gains for each of the nine input
channels.
8.50. FLASH -- Execute Hook Flash
This command puts the phone on-hook and then takes it back off-hook after a delay. The amount of time
between on-hook and off-hook is controlled by the COUNTRY setting and has be set for each country to meet
each country's specific compliance requirements. If the phone is on-hook when this command is given, then
no action is performed.
Example Description Status Message

Table of Contents

Other manuals for Polycom Vortex EF2241

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom Vortex EF2241 and is the answer not in the manual?

Polycom Vortex EF2241 Specifications

General IconGeneral
BrandPolycom
ModelVortex EF2241
CategoryTelephone Accessories
LanguageEnglish

Related product manuals