B01FLASH
Execute hook flash.
If the phone is on-hook, no action is performed, and the response will be
B01FLASH
If the phone is off-hook, the response will be
B01FLASH
B01PHONE0
B01PHONE1
The PHONE status messagges occur when the phone goes on-hook and
back off-hook.
8.51. FLOW -- Set Flow Control Mode for RS-232 Port
This command sets the flow control mode for the rear panel RS-232 port. The valid settings are:
Command Value Description
0 No flow control.
1 Hardware flow control.
2 Auto-detect hardware flow control or no flow control.
We recommend using hardware flow control whenever possible, especially when using higher baud rates.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
time it is changed. It will retain its value after power-down. Since this command writes to non-volatile
memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
B01FLOW1
Set rear panel RS-232 port to use hardware flow
control.
B01FLOW1
B01FLOW?
Query flow control setting of rear panel RS-232
port.
B01FLOWx , where x is 0, 1, or 2
depending on the current flow control
setting.
8.52. FPLOCK -- Lock/Unlock Front Panel
This command controls the front panel lock feature. When FPLOCK is enabled, the user may not make any
changes to the system via the front panel. The system settings will still be viewable on the LCD, but the user
will get an error message if he tries to change them. When FPLOCK is disabled, the user has full access to
the system settings via the front panel.
Usage of this command is similar to other boolean commands (see
Section 6.1) except that when disabling
this feature, the password must be supplied for the command to work. If an incorrect password is supplied,
'ERROR#005' will be generated. The examples below illustrate the correct usage. The examples assume that
the password has been set to 'aspi' (the default). The front panel password can be changed via the
FPPSWD command.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
To Next Page
Loading...
Need help?
General
