Polycom Vortex EF2241 - VTXMODO - Enable VTX Mode on Specified Outputs

B01VTXMODI*1100
Enable VTX mode on inputs A-B
and disable VTX mode on inputs
C-D .
B01VTXMODI*1100
B01VTXMODI*2
Toggle status of VTX mode on
inputs A-D .
B01VTXMODI*abcd , where each of the letters (a,
b, etc.) is either 0 or 1 depending of the current
status VTX mode on the corresponding input. If this
command was sent after the example above, then
the status message would be B01VTXMODI*0011 .
B01VTXMODI*?
Query status of VTX mode on
inputs A-D .
B01VTXMODI*abcd , where each of the letters (a,
b, etc.) is either 0 or 1 depending of the current
status VTX mode on the corresponding input. If this
command was sent after the example above, then
the status message would be B01VTXMODI*0011 .
8.159. VTXMODO -- Enable VTX Mode on Specified Inputs
Vortex devices can be connected to a Polycom VTX 1000 in order to use the wideband capabilities of that
device. When connecting to a VTX 1000, special proccessing is done on the Vortex in order to guarantee
compatibility with the VTX 1000. This command enables processing for the VTX 1000 on the specified line
output or outputs.
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01VTXMODO11
Enable VTX mode on
output 1.
B01VTXMODO11
B01VTXMODOA0
Disable VTX mode on
output A.
B01VTXMODOA0
B01VTXMODO12
Toggle status VTX mode
on output 1.
B01VTXMODO1x , where x is either 0 or 1
depending on the current status of VTX mode on
output 1.
B01VTXMODOA?
Query status of VTX mode
on output A.
B01VTXMODOAx , where x is either 0 or 1
depending on the current status of VTX mode on
output A.
B01VTXMODO*1
Enable VTX mode on
outputs 1-4, A-D .
B01VTXMODO*11111111
B01VTXMODO*0
Disable VTX mode on
outputs 1-4, A-D .
B01VTXMODO*00000000
B01VTXMODO*11100100
Enable VTX mode on
outputs 1-4 and disable
VTX mode on outputs A-D
.
B01VTXMODO*11110000