Polycom Vortex EF2241 User Manual

information. To set the frequency parameter for an input parametric EQ filter, use the PEQIF command. To
set all the parameters for an input parametric EQ filter, use the
PEQIA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01PEQOF3,2,1250
Set frequency of parametric EQ
on output 3 , band 2 to 1250
Hz.
B01PEQOF3,2,1250
B01PEQOFB,1,?
Query current frequency
setting of parametric EQ on
output B , band 1.
B01PEQOFB,1,f , where f is the current setting of
the frequency parameter for the parametric EQ on
output B , band 1. If the frequency parameter of
this filter is set to the same value given in the
example above, then the status message will be
B01PEQOFB,1,1250 .
8.129. PEQOG -- Set Gain Parameter for Specified Parametric
EQ Output Stage
This command sets or queries the gain parameter (in dB) for the parametric equalizer (EQ) filters on output
channels 1-4, A-D, T, and L . Each channel has five bands of parametric EQ that can be independently
controlled.
The minimum and maximum values for the gain parameter are -20 and 20, respectively.
This command has the same format and restrictions as the
PEQOA command except that only one
parameter, the gain, is specified instead of all the parameters. See the
PEQOA command for more
information. To set the gain parameter for an input parametric EQ filter, use the
PEQIG command. To set all
the parameters for an input parametric EQ filter, use the
PEQIA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01PEQOG3,2,-20
Set the gain of the parametric EQ
on output 3 , band 2 to -20 dB.
B01PEQOG3,2,-20
B01PEQOGB,1,?
Query current gain setting of
parametric EQ on output B , band 1.
B01PEQOGB,1,g , where g is the current
setting of the gain parameter for the parametric
EQ on output B , band 1. If the gain parameter
of this filter is set to the same value given in the
example above, then the status message will be
B01PEQOGB,1,-20 .
8.130. PEQOS -- Set Slope Parameter for Specified Parametric
EQ Output Stage

Polycom Vortex EF2241 Specifications

General

Brand	Polycom
Model	Vortex EF2241
Category	Telephone Accessories
Language	English