B01MUTEO*2
Toggle mute status of all
outputs.
B01MUTEO*abcdefghij where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding output. If
this command was sent after the example above,
then the status message would be
B01MUTEO*0000111101 .
B01MUTEO*?
Query mute status of all
outputs.
B01MUTEO*abcdefghij , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding output. If
this command was sent after the example above,
then the status message would be
B01MUTEO*0000111101
8.113. NC -- Enable Noise Cancellation
This command sets or queries the status of the Noise Cancellation (NC) algorithm on input channels 1-4 and
T .
When the wildcard character, '*', is used to specify the channel in this command, it only affects input
channels 1-4 . To set or query the telephone input channel, T, you must specify it explicitly (e.g., 'B01NCT1'
'' '', 'B01NCT?' '' '').
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01NC31
Enable NC on input channel 3 .
B01NC31
B01NCT0
Disable NC on input channel T.
B01NCT0
B01NC12
Toggle NC state on input channel 1 .
B01NC1x , where x is 0 or 1 depending on the
current state of NC on input channel 1 .
B01NCT?
Query NC state on input channel 1 .
B01NCTx , where x is 0 or 1 depending on the
current state of NC on the input channel.
B01NC*1
Enable NC on input channels 1-4 and T .
B01NC*1111
B01NC*0
Disable NC on all microphone input channels
(1-4) .
B01NC*0000
B01NC*2
Toggle NC state on all microphone input
channels (1-4) .
B01NC*abcd , where the letters (a, b, etc.) are
each 0 or 1 depending on the current state of NC
for each of the corresponding input.
B01NC*?
Query NC state on all microphone input
channels (1-4) .
B01NC*abcd , where the letters (a, b, etc.) are
each 0 or 1 depending on the current state of NC
for each of the corresponding input.
8.114. NCL -- Set Noise Cancellation Attenuation
To Next Page
Loading...
Need help?
General
