B01PEQIGB,1,?
Query current gain setting of
parametric EQ on input B , band 1.
B01PEQIGB,1,g , where g is the current
setting of the gain parameter for the parametric
EQ on input B , band 1. If the gain parameter of
this filter is set to the same value given in the
example above, then the status message will be
B01PEQIGB,1,-20 .
8.123. PEQIS -- Set Slope Parameter for Specified Parametric
EQ Input Stage
This command sets or queries the slope parameter (in dB per octave) for the parametric equalizer (EQ) filters
on input channels 1-4, A-D, and T . Each channel has five bands of parametric EQ that can be independently
controlled.
For the Linkwitz-Riley filters, the slope can either be 12 or 24 (dB/Octave).For the low shelf and high shelf
filters, the minimum value for the slope parameter is 1, and the maximum value is 1.2 times the current
value of the gain parameter. See the
PEQIG command for information on the gain parameter.
This command has the same format and restrictions as the
PEQIA command except that only one
parameter, the slope, is specified instead of all the parameters. See the
PEQIA command for more
information. To set the slope parameter for an output parametric EQ filter, use the
PEQOS command. To set
all the parameters for an output parametric EQ filter, use the
PEQOA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01PEQIS3,2,1
Set the slope of the parametric EQ
on input 3 , band 2 to 1 dB per
octave.
B01PEQIS3,2,1
B01PEQISB,1,?
Query current slope setting of
parametric EQ on input B , band 1.
B01PEQISB,1,s , where s is the current setting
of the slope parameter for the parametric EQ on
input B , band 1. If the slope parameter of this
filter is set to the same value given in the example
above, then the status message will be
B01PEQISB,1,1 .
8.124. PEQIT -- Set Type Parameter for Specified Parametric
EQ Input Stage
The type parameter specifies what type of filter is executed for the specified band of the specified input
channel. The different filter types and their corresponding values are shown in the table below.
Filter Type Value of Type Parameter
Parametric 1
Low Shelf 2
To Next Page
Loading...
