Whether or not the modem initialization string is sent at power-up is controlled via the MINI command.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
time it is changed. It will retain its value after power-down. Since this command writes to non-volatile
memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
B01MINISTRATF1E0&B1S0=2
Set modem initialization
string to ATF1E0&B1S0=2.
B01MINISTRATF1E0&B1S0=2
B01MINISTR?
Query current modem
initialization string.
B01MINISTR<string> , where <string> is
the current modem initialization string. If this
command was sent after the above example,
then the status message would be
B01MINISTRATF1E0&B1S0=2 .
8.108. MMUTE -- Mute Crosspoint in Main Matrix or Submatrix
This command sets or queries the mute status of one or more crosspoints in either the main matrix or one of
the EF Bus submatrices.
This command is a matrix boolean command. See
Section 6.4 and Section 6.1 for more information on this
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
B01MMUTEB,R1,1
Mute signal path
(in main matrix)
from input B to
AEC reference 1
.
B01MMUTEB,R1,1
B01MMUTEWB0,WM0,0
Mute signal path
(in EF Bus W
submatrix) from
W bus signal at
device ID0
(WB0) to W
submatrix
output 0
(WM0).
B01MMUTEWB0,WM0,0
B01MMUTE1,B,2
Toggle mute
status of signal
path (in main
matrix) from
input 1 to
output B .
B01MMUTE1,B,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.
To Next Page
Loading...
Need help?
General
