B01MMUTEA,W,?
Query mute
status of signal
path (in main
matrix) from
input A to W-
Bus output .
B01MMUTEA,W,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.
B01MMUTE1,*,11110000000000000
Set all
crosspoint
mutes for input
channel 1. Mute
the paths from
input 1 to
outputs 1-4 and
unmute the
paths from
input 1 to
outputs A-D,
R1, R2, T, L, P,
W, X, Y, and Z.
B01MMUTE1,*,11110000000000000
B01MMUTE2,*,0
Unmute all
crosspoints for
input channel 2
.
B01MMUTE2,*,00000000000000000
B01MMUTE2,*,2
Toggle all
crosspoint
mutes for input
channel 2 .
B01MMUTE2,*,abcdefghijklmnopq , where
the value of each of letters (a, b, etc.) is either 0
or 1 depending on the current state of each of
the crosspoint mutes. If this command was
issued after the example above, then the status
message would be
B01MMUTE2,*,00000000000000000
B01MMUTE2,*,?
Query all
crosspoint
mutes for input
channel 2 .
B01MMUTE2,*,abcdefghijklmnopq , where
the value of each of letters (a, b, etc.) is either 0
or 1 depending on the current state of each of
the crosspoint mutes. If this command was
issued after the example above, then the status
message would be
B01MMUTE2,*,00000000000000000
8.109. MUTEGIL -- Set Mute Status of Line Inputs as a Group
This command sets the mute status of all the line inputs simultaneously. This is different from using a
wildcard, * with the MUTEI command because that command sets all the mic and line inputs together, while
the MUTEGIL sets only the line inputs.
This command will generate acknowledgements from each of the line inputs separately.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
To Next Page
Loading...
