FlexFit 110 Linkageless Control
Copyright © 2018 Preferred Instruments – All Rights Reserved Worldwide
The information contained herein is provided in good faith but is subject to change without notice. It is supplied with no warranty
whatsoever and does not represent a commitment on the part of Preferred Instruments. Companies, names, and data used
as examples herein are ctitious unless otherwise stated. No part of this document may be reproduced or transmitted in any
form or by any means, electronic or mechanical, without the express written permission of Preferred Instruments.
The Preferred Instruments logo is a registered trademark ® of Preferred Instruments.
FlexFit, FlexFit Edit, and the FlexFit logo are trademarks ™ of Preferred Instruments.
All other trademarks are acknowledged as the property of their respective owners.
WARNING
If improperly installed or irresponsibly used, the equipment covered in this
manual can cause extreme property damage, severe injury, or death. It
is the responsibility of the owner and user to ensure that the equipment
described herein is installed, commissioned, and used in compliance with the
requirements of all national and local legislation, whichever may prevail.
The FlexFit is used to control potentially dangerous boiler, burner, and com-
bustion processes. Only qualied instrument engineers or senior technicians
that have read this entire manual and are familiar with all aspects of the
processes being controlled should attempt to install and commission this
controller. Only qualied operators that are familiar with all aspects of the
processes being controlled should attempt use this equipment. Failure to
do so can result in extreme equipment damage, severe injury, or death.
Revision Changes Author
1.0 Initial Release BKB
To Next Page
Loading...
Need help?
General
