MAX™ Operator Manual
©
Original Printed In English
SECTION 6 - FAULT & ALERT MANAGE-
6-7
ALERT
CAUSE
SOLUTION
Infeed Conveyor Out Of Parts Applies when equipped with an EZ-
Feed Integrated Conveyor. The con-
veyor was running in Parts Counting
Mode and not parts are being count-
ed at the Parts Counting Light Cur-
tain. The conveyor is either empty or
there is a problem with the Part
Counting device.
Load parts on the conveyor belt and
the Cycle Start device. Conveyor
should resume running to count
parts.
E-Stop Button Pressed The E-Stop button is pressed. Twist to release the E-Stop.
Service Mode Testing Model Selec-
tion
Service Personnel are testing the
Model Selection Circuits. No cycle is
possible.
Service person should cancel this
function when finished with testing.
Low Pressure Air Timed Out Low Pressure Air Timed Out No intervention required by opera-
tor.
Machine Not Tested The bagger has not passed the QA
test of 1000 cycles without a fault.
Bagger should be run for 1000 con-
tinuous cycles without a fault to
clear alert.
Waiting For Printer The bagger requested a print form
the printer, but the printer has not
responded with “Printer Busy”.
Printer is either not printing or there
is a signaling problem between the
PLC and the printer.
Factory Settings Loaded The settings stored in the PLC have
been recalled by the user.
This is simply an alert to let the user
know that the setting have been
successfully reloaded.
To Next Page
Loading...
