Prodys ProntoNet LC - III.2.1.1. Establishing a Call When Prontonetlc Is Configured as an IP Codec

ProntoNetLC User Manual 23
III.2.1.1. Establishing a call when ProntoNetLC is configured as an IP codec
Pressing CALL 1 the screen will display the following:
The user must select beforehand if the IP communication type is MULTICAST
mode (point to multi-point) or UNICAST mode (point to point). Next, depending
on the selected option will show:
MULTICAST 


To make the connection press OK. “Period” is selected with the # key.
UNICAST 


L A N L 1 M O D E
{ M U L T I C A S T } U N I C A S T
L A N L 1 M O D E
{ M U L T I C A S T } U N I C A S T
L A N L 1 M O D E
{ T x } R x
L A N L 1 M O D E
M U L T I C A S T { U N I C A S T }
L A N L 1 M O D E
{ U N I D I R } B I D I R
L A N L 1 D I A L
2 2 4 . 0 . 0 . 1
O
K
O
K
O
K
O
K