ProntoNetLC User Manual
49
S E T L O O P
{ C O D E C 1 } C O D E C 2
< < S E T R S 2 3 2 P O R T A
1 2 0 0 2 4 0 0 4 8 0 0 9 6 0 0
S Y S M E N U »
{ L O O P } P L L F A N
« S Y S M E N U »
F A N { A U X D A T A } K E Y P A D
« S Y S M E N U »
Y P A D I P C O D E C B U Z Z E R
« S Y S M E N U
B U Z Z E R R E S E T
Port B is only available if the unit is working as a DUAL codec
19
, i.e. each line
is working independently.
IV.6.3 CONF-SYS
Grouped here are functions that affect the general operation of the unit.
IV.6.3.1. Loop
This sets up an Encoder-Decoder loop. Its purpose is to help the user when there
are installation problems. The loop takes place in accordance with the
configuration available at that moment:
19
DUAL codec: ProntoNetLC is able to operate as a DUAL codec over IP (when configured in
‘DOUBLE’ mode).
To Next Page
Loading...
