Prodys ProntoNet LC - (Net = X21); III.2.1.3. Establishing a Call When Prontonetlc Is Configured as an X21 Codec; Unicast Codec (NET = IP)

ProntoNetLC User Manual 24
To make the connection press OK. “Period” is selected with the # key.
III.2.1.2. Establishing a call when ProntoNetLC is configured as an IP Multi-
Unicast
5
codec (NET = IP)
Pressing CALL 1 the screen will display the following:
Group Redial is the only option available when calling from the front panel. This
option will try to re-establish all previous connections, both Tx and Rx.
CALL 2 key is not available under Multi-Unicast mode.
III.2.1.3. Establishing a call when ProntoNetLC is configured as an X21 codec
(NET = X21)
6
When ProntoNetLC is set up for dedicated lines (NET = X21) it is not necessary
to talk about establishing connections in the same way as we have been doing
with IP networks and ISDN. Actually, the CALL 1 key simply enables or disables
communication via the X21 port. The CALL 2 key does nothing as there is only
one X21 port available.
To connect the Line in X21 press CALL1. To disconnect the line press
CALL1 over 1 second.
Each Key has an associated LED that indicates the following situations:
LED off: Line disconnected
LED on: Line connected
5
This option is available under license.
6
This option is available under license.
L A N L 1 M O D E
{ T x } R x
L A N L 1 D I A L
1 0 . 0 . 0 . 0
O
K
M U L T I U N I C A S T C A L L
{ G r o u p R e d i a l }