ProntoNetLC User Manual
51
G P I O D A T A M E N U
{ O F F } D E C 1 D E C 2
K E Y S L O C K E D
P R E S S O K A N D T H E N *
K E Y P A D M E N U
{ A U T O L O C K } P A S S W O R D
E N T E R P A S S W O R D
There is only one GPIO interface for two decoders (if the second is available)
so the user has to configure which decoder will carry the GPIO information.
IV.6.3.5. KEYPAD
This option allows the user to enable/disable automatic keypad locking and
password protection. When enabled, the unit will automatically lock keys from
the front panel, one minute after last key was pressed. To unlock, just press OK
and * keys, and enter the password, if the password was enabled.
INF won’t be disabled.
CALL1 and CALL2 keys will be available to answer any incoming call.
When the keypad is locked, and any key is pressed, the following message
appears:
If password protection was enabled, the user will be prompted to enter
the password, and the following message appears:
If the password is entered successfully, the following message appears:
To Next Page
Loading...
