ProntoNetLC User Manual
52
A L L K E A Y P A D
U N L O C K L E D
B U Z Z E R
E N A B L E { D I S A B L E }
R E S E T S Y S T E M ?
R E S E T { C A N C E L }
S E T C O D E C
S I M P L E { D O U B L E }
IV.6.3.6. IPCODEC
There are two different operation modes: SIMPLE and DOUBLE mode. In SIMPLE
mode, the unit will work as usual, that means, it cannot establish two
independent communications via IP. In DOUBLE mode, the unit can establish
two independent communications via IP.
In DOUBLE mode over IP, the following restrictions will be applied:
1.- Encoder 1 and Encoder 2 can only be set in MONO.
2.- Encoder 2 (assigned to line 2) can only be set in G722.
IV.6.3.7. BUZZER
It is possible to enable/disable the buzzer from this option. The buffer warns the
user about incoming calls.
IV.6.3.8. RESET
It is possible to reset the device by selecting this option. The system will ask the
user to confirm this selection before rebooting the unit.
To Next Page
Loading...
