ProntoNetLC User Manual
75
K E Y S L O C K E D
P R E S S O K A N D T H E N *
E N T E R P A S S W O R D
V.1.3 System Configuration
Grouped here are functions that affect the general operation of the unit.
Loop: This sets up an Encoder-Decoder loop. Its purpose is to help the user
to find problems with audio connections. The loop takes place in accordance
with the configuration available at that moment.
PLL: This is a special option that allows you to select the PLL reference clock
when NET = IP.
Redial:It is possible to configure a number of redials. The ProntoNetLC will
try the connection in the following cases:
1.- The unit is trying the connection for the first time.
2.- The unit was connected and lost the connection because the line
dropped or the line was disconnected from the other end.
Keypad: This option allows the user to lock automatically the frontal panel
keypad. Automatic means that the keypad is locked a short while (around 1
minute) after you just press a key. It is possible to unlock from the keypad by
pressing Ok and then *.
It is also possible to lock the keypad with a password.
INF won’t be disabled.
When the keypad is locked, and any key is pressed, the following message
appears:
If password protection was enabled, the user will be prompted to enter
the password, and the following message appears:
If the password is entered successfully, the following message appears:
To Next Page
Loading...
