raid= Used to specify the RAID level of the pool Only valid for add action with
physical drive type.
0 Striping.
1 Mirroring on two drives.
5 Parity, requiring 3 or more drives.
10 Mirroring on even number of drives.
50 Striping on multiple RAID 5, requiring 6 or more drives.
6 Allow two drive failure, requiring 4 or more drives.
60 Striping on multiple RAID 6, requiring 8 or more drives.
stripe= Used to specify the stripe size.
The possible parameters are 64KB, 128KB, 256KB, 512KB, and 1MB. If
not specied, the default 64K will be used.
Only valid for add action with physical drive type
sector= Used to specify the desirable sector size.
The possible parameters are 512B, 1KB, 2KB, and 4KB.
It must not be greater than the Stripe size.
It will be auto-adjusted not to exceed the max supported sector size of the
controller, please see controller info
If not specied, for advanced type, the default 4KB will be used; for
standard type, the default 512B will be used
Only valid for add action with physical drive type.
Axle= RAID 50, 3 to 32 drives per axle.
RAID 60, 4 to 32 drives per axle.
Valid for add action with physical drive type or expand action on the pool
created by physicsl drive with new drives is physical drive too.
263
Promise Technology
Managing with CLI
To Next Page
Loading...
Need help?
General
