Viewing iSCSI Target Information
To view information about the iSCSI target:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Target tab. (Note that you need to click Expand Detail Information to view the entire list)
Target information includes:
• ID – ID number of the target.
• Status – Up or down.
• Name – iSCSI qualied name (iqn) of this target.
• Alias – Maximum of 32 characters. Use letters, numbers, space
between words, and underscore. An alias is optional.*
• Error Recovery Level – Error recovery level supported.
• Initial R2T – Allows initiator to begin sending data to a target
without receiving a ready to transfer command.
• Max Outstanding R2T – Maximum number of R2T PDUs the target
can have outstanding for a single iSCSI command.
• Max Burst Length – Maximum length of a solicited data sequence in bytes.
• Data Digest – Adds a data digest (CRC).*
• Header Digest – Enables the use of header digest (CRC).*
• Data PDU in Order – Enables placement of data in PDU order
• Data Sequence in Order – Enables placement of data in sequence order
• Default Time to Wait – After a dropped connection, the number
of seconds to wait before attempting to reconnect
• Default Time to Retain – Number of seconds after time to wait
(above) before reassigning outstanding commands
• Uni-directional CHAP Authentication – Uni-directional (peer)
CHAP authentication, enabled or disabled*
• Bi-directional CHAP Authentication – Bi-directional (local)
CHAP authentication, enabled or disabled*
• Maximum Connections – The maximum number of concurrent connections
• Immediate Data – Enables the initiator to send unsolicited data with the iSCSI command PDU.
• First Burst Length – In bytes.
• Assigned Portal IDs
• Keep Alive - Enable or Disable
ManagIng IscsI connectIons
129
Promise Technology
Management with WebPAM PROe
To Next Page
Loading...
Need help?
General
