When the update is completed a message tells you to reboot the subsystem,
7. Click the OK button.
• If you chose the Disruptive Flash Method, the RAID subsystem
and JBOD expansion units automatically restart.
• If you chose the Non-Disruptive Flash Method, the system automatically
ashes and restarts the RAID controllers one at a time.
Automatic Restart
If you did NOT check the NDIU box, the RAID subsystem and JBOD expansion units automatically restart. That
action temporarily disrupts I/O operations and drops your WebPAM PROe connection.
To reestablish your WebPAM PROe connection:
1. Wait no less than two minutes.
2. Click Logout in the WebPAM PROe Header, then log in again.
If you cannot log in, wait 30 seconds and try again.
3. In your browser, click Logout in the WebPAM PROe Header, then log in again.
If you cannot log in immediately, wait 30 seconds and try again.
Product Registration
Access the Product Registration menu located in the Administration tab to register your Vess product. If you
do not have an account, follow the links and instructions to create a new account.
In the Sign In menu, enter the Email ID and Password for your Promise account and click on Submit. If you
do not have an account, click the Don’t have a Promise ID? radio button, click Submit and enter the required
information to create an account in the new menu.
168
Promise Technology
Vess R3600 / Vess J3600 Product Manual
To Next Page
Loading...
Need help?
General
