Promise Technology Vess R3600 Series User Manual

Power button
Power button on front left of Vess R3600
Connecting the Power
Vess R3600 and Vess J3600 enclosures are equipped with two power supply units (PSU) for each enclosure;
each PSU has its own ON/OFF switch. Connect both power supplies to a suitable power source.
Power on
Withthepowersuppliesconnected,thesystem(s)cannowbepoweredon.Thepowersupplymodulesinclude
the cooling fans that cool the enclosure. Both power supplies should be powered up when starting the system.
Make sure the power switch on each power supply is in the On position.
If you are using Vess J3600 JBOD enclosures, power these units on BEFORE powering on the Vess R3600
enclosure. To power on the Vess J3600, toggle the power switch on each PSU to the ON position. See “Vess
R3600 Power Supply Components” on page 39 for PSU description. To power on the Vess R3600 subsystem,
press the Power button on the front left bracket facing (see illustration below). Observe the LEDs on the right
front bracket facing.
Important
If you are using the Vess J3600 JBOD enclosure,
power the JBODs on rst.
34
Promise Technology Vess R3600 / Vess J3600 Product Manual

Promise Technology Vess R3600 Series Specifications

General

Brand	Promise Technology
Model	Vess R3600 Series
Category	Storage
Language	English