Placement Setup
8 CubiScan 125
F RS-232 communications cable
G USB cable
H USB driver CD
I Cable ties
J Wrench
K Calibration block
L Operations and Technical Manual (this manual) and Qbit
software CD (optional)
If any of the components or accessories are missing or defective,
contact Quantronix or your system integrator.
Carefully remove the CubiScan 125 and its components from the
crate, and place the CubiScan 125 on a solid, stable surface for
assembly (see “Assembling the CubiScan 125” on page 9.
Placement
The CubiScan 125 is designed to be operated in a warehouse envi-
ronment; however, for proper operation the following conditions
should be met if possible.
• Do not subject the CubiScan 125 to extremes in temperature or
humidity. Locate the CubiScan 125 as far from open freight
doors as possible. Heaters or air conditioners should not blow
directly on the CubiScan 125.
• Protect the CubiScan 125 from static electricity, especially the
touch screen.
• Place the CubiScan 125 on a flat, sturdy surface as free from
vibration as possible. Excess vibration can reduce the accuracy
of the CubiScan 125 scale.
• The CubiScan 125's platform is free-floating—it is resting on a
spring (load cell). Maintain a minimum of one-inch clearance at
To Next Page
Loading...
Need help?
General
