Installing Qbit (Optional) Setup
32 CubiScan 125
When it is turned on, the CubiScan 125 will recognize the cable
connection and, if configured correctly, will respond to a connection
request from the host.
NOTE
You can also connect the CubiScan 125 directly to a computer
through a 10/100Base-T Ethernet TCP/IP port via a standard
Ethernet cable. A crossover cable is required.
Installing Qbit (Optional)
A CD-ROM is available containing the Qbit software program,
which can be used to operate the CubiScan 125
The Qbit User Guide, located on the CD-ROM, provides instruc-
tions for installing and using Qbit. You can also download the user
guide from the Quantronix Web site at www.cubiscan.com.
Setup Checklist
Before using the CubiScan 125 for the first time, verify the follow-
ing:
❒ Have the CubiScan 125 and the computer (if applicable) been
placed in the proper operating environment? (page 8)
❒ Has the CubiScan 125 been fully assembled? (page 9)
❒ Has the height sensor cable been connected to the sensors?
(page 13)
❒ Have all screws been tightened?
❒ Has all shipping material been removed? (page 17)
☞
To Next Page
Loading...
Need help?
General
