Setup Setup Checklist
CubiScan 125 33
❒ Is the CubiScan 125 free moving? The CubiScan 125 should not
be pushed up against a wall and no object, cable, etc., should be
resting on it or against it.
❒ Has the RS-232, USB, or RJ-45 cable been attached to the
CubiScan 125 and the computer or network (if applicable)?
(page 21)
❒ Has the AC power cord been connected correctly? (page 32)
❒ If you are using Qbit to operate the CubiScan 125, has the soft-
ware been copied onto your computer's hard-disk drive? (Refer
to the Qbit User Guide for information.)
❒ Does the CubiScan 125 require recalibration? The CubiScan
125 was calibrated at the factory, but may require recalibration
due to handling during shipping. Refer to page 59 for informa-
tion on calibrating the CubiScan 125. If you are using Qbit soft-
ware, check the status of the CubiScan 125 before operating it.
Refer to the Qbit User Guide for information on checking the
CubiScan 125’s status.
To Next Page
Loading...
