CubiScan 125 35
Chapter 3
Operation
This chapter provides instructions for operating the CubiScan 125.
NOTE
The platform of the CubiScan 125 should be kept clean and free of
objects that are not being measured.
Before You Begin
Follow the procedures below to turn on the CubiScan 125. The
CubiScan 125 should be turned on before you start Qbit (if applica-
ble).
1. Make sure there are no packages or objects on the CubiScan
125 platform.
2. Turn on the CubiScan 125. The CubiScan 125 performs
self-calibration and diagnostic procedures that take about 5 sec-
onds. Do not touch the CubiScan 125 platform during these
5 seconds.
NOTE
Do not lean on or touch the CubiScan 125 platform or the package
while a package is being cubed and weighed. Any kind of contact
with the platform during the measurement process can alter the
weight or sensor reading.
☞
☞
To Next Page
Loading...
Need help?
General
