RADWAG PUE C32

20
Where:
Capital letters mode. To change keyboard working mode press key.
Keyboard working mode options:
- upper-case character mode, - lower-
case character mode,
- digit mode, - arrow keys operation, - bottom
bar operation.
Press to save the project to *.lb file on a USB flash drive.
Press to read the project saved to *.lb file on a USB flash drive.
Press to clear box content.
Press to print the project using a printer connected to the scale.
Press to view list of variables that can be used in the project.
Keys:
Press to enter . , { } : ° - .
Press to enter a b c. Press to move the cursor to the left, hold the key for a few
seconds.
Press to enter d e f. Press to move the cursor up, hold the key for a few
seconds.
Press to enter g h i. Press to move the cursor to the right, hold the key for a
few seconds.
Press to enter j k l. Press to enter„ - ” sign, hold the key for a few seconds.
Press to enter m n o. Press to activate „ąëñ” function (diacritical signs table),
hold the key for a few seconds.
Press to enter p q r s. Press to activate „!$&” function (special signs table),
hold the key for a few seconds.
Press to enter t u v. Press to move the cursor down, hold the key for a few
seconds.
Press to enter w x y z. Press to activate „Caps Lock” function, hold the key for
a few seconds.
Press to enter (space) sign. Press to enter „.” sign (dot), hold the key for a
few seconds. ”.
Press to go to the next line in the edit box.