33
2. Enter <Peripherals / Computer / Port> submenu and set USB B option.
3. Run program for measurement readout.
4. Set communication parameters – select COM port that was installed in the
course of drivers installation (in this very case it is COM8).
5. Start cooperation.
15. PERIPHERAL DEVICES
15.1. Computer
The weighing device can connect with a computer. Active 'scale' – 'computer'
connection is signalled by
pictogram (top bar of the home screen).
To configure 'scale' - 'computer' connection settings go to <
/
Peripherals / Computer> submenu.
15.1.1. Port
Parameter allowing you to set port for communication between the weighing
device and the computer. Available ports:
RS232 (1)
RS232 port (DB9/M connector).
RS232 (2)
RS232 port (DSUB15/F connector).
USB B
USB port of type B.
Ethernet
Ethernet port (RJ45 connector)
Wireless
communication
Port for sending data to a computer via wireless network.
Procedure:
• Enter <Peripherals / Computer / Port> submenu and select respective
port, <Port settings> submenu differs depending on the selected port:
Port Settings
RS232 (1)
RS232 (2)
Baud rate: 2400 - 115200 bit/s.
Parity: None, Odd, Even.
USB B
-
Ethernet
Wireless
communication
IP Address: IP address of the scale.
Port: number of port for transmission protocol.
Timeout [ms]: time delay - time interval for disconnection, counted from
the moment of the most recent command sent from the peripheral
device to which the weighing device is connected.
To Next Page
Loading...
