70
If you decide that the reference sample features the right amount of pieces, you
can record weight value of a single piece to a weighing device memory and
deactivate the function by pressing
key.
27.2.2. Minimum Reference Sample Mass
Prior to determining single piece weight value you can declare „Minimum
reference sample mass, i.e. minimum weight value for the total mass of all
pieces loaded onto the weighing pan, expressed in reading units.
Procedure:
• Enter <Working modes / Parts counting / Minimum reference sample
mass> submenu and set respective option.
Values: 1 d, 2 d, 5 d, 10 d.
Total mass of all the pieces loaded onto the weighing pan
must not be lower than the value declared in „Minimum
reference sample mass” parameter. Unless this condition is
met, the weighing device displays a message: <Sample mass
too low>.
27.3. Setting Reference Sample Mass by Entering Mass of a Single Part
• Press button (Set part mass), <Reference sample mass> edit box
featuring an on-screen keyboard is displayed.
• Enter respective value and press
key to confirm, <Parts
counting> working mode is run with automatically set mass of a single
part.
If the value of the entered single part mass is greater than the
max capacity value, then the following message is displayed:
<Value too high>.
If the value of the entered single part mass is lower than 0.1
of the reading unit, then the following message is displayed:
<Value too low>.
27.4. Setting Reference Sample Mass by Determining Mass of a Single
Part
If the parts are to be weighed in a container, first put the container
on a weighing pan and tare it.
To Next Page
Loading...
