80
• Visualisation of mass value higher than the value of [DT2] threshold:
• Upon exceeding the value of fast dosing threshold, fast dosing outputs are
activated.
• Upon exceeding the value of dosing threshold, dosing outputs are
activated and OK process status is displayed.
• Upon stability of the weighing result, the process is assigned with
Completed status (process completed). Blinking pictogram
is turned
off.
Manual dosing:
• Visualisation of mass value lower than MIN value:
• Visualisation of mass value higher than MIN value and lower than MAX
value:
• Visualisation of mass value higher than MAX value:
29.5. Dosing Process Report
Dosing report is automatically generated at the end of each dosing process,
next it is sent to port selected for <Peripherals / Printer>. To declare report
content go to <Printouts / Dosing report> submenu. For instruction on how to
declare adjustment report settings read section 'Printouts'.
DT1=1.600kg
DT2=1.800kg
Min=1.600kg
Max=1.800kg
Min=1.600kg
Min=1.600kg
Max=1.800kg
Max=1.800kg
To Next Page
Loading...
