RADWAG PUE C32

46
17. INPUTS / OUTPUTS
Standard version of PUE C32 indicator is equipped with 4 inputs and 4 outputs.
In order to set inputs and outputs enter: <
/ Inputs / Outputs>.
17.1. Input Setup
• Enter <Inputs / Outputs> submenu.
• Select <Inputs> parameter and edit respective input, list of functions that
can be assigned to the input is displayed. Input functions list is identical
like key functions list, read section 18.2.
• Select the function you want to assign to the input, next go back to the
home screen.
By default all functions are assigned with <None> value.
17.2. Output Setup
Output gets activated at the moment of assigning it with a given function.
Unassigned outputs remain inactive.
Procedure:
• Enter <Inputs / Outputs> submenu.
• Select <Outputs> parameter and edit respective output, list of functions
that can be assigned to the output is displayed.
None Output inactive.
Stable Stable weighing result over LO threshold value.
MIN stable Stable weighing result below the MIN threshold.
MIN unstable Unstable weighing result below the MIN threshold.
OK stable Stable weighing result between MIN and MAX thresholds.
OK unstable Unstable weighing result between MIN and MAX thresholds.
MAX stable Stable weighing result over the MAX threshold.
MAX unstable Unstable weighing result over the MAX threshold.
Zero Zero weighing result („zero” marker).
! OK unstable Unstable weighing result out of OK threshold.
! OK stable Stable weighing result out of OK threshold.
MIN MIN threshold signalling.