RADWAG PUE C32

58
Where:
Sound signal enabled.
Sound signal disabled.
21.3. Display Brightness
Parameter allowing you to change display brightness, the brightness can be
changed within 0% - 100% range.
Procedure:
• Enter <Misc / Display brightness> submenu and set respective value.
Available values: 0%, 10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%, 90%,
100% (set by default).
21.4. Proximity Sensors Sensitivity
Parameter allowing you to adjust distance within which the proximity sensors
are to be operated. The distance can be adjusted within 0% - 100% range, for
lower values the proximity sensors operate at a shorter distance.
Procedure:
• Enter <Misc / Proximity sensors sensitivity> submenu and set
respective value.
Available values: 0%, 10%, 20%, 30%, 40%, 50% (set by default), 60%, 70%,
80%, 90%, 100%.
21.5. Date and Time
Parameter allowing you to set current date and time and to specify date and
time format.
Procedure:
• Enter <Misc / Date and time> submenu and change the settings. Refer to
the below table:
Parameter Description
Date Enter this parameter to set current date.
Time Enter this parameter to set current time.
Date format *
Enter this parameter to set date format. Options: YYYY.MM.DD (set by
default), YYYY.DD.MM, DD.MM.YYYY, MM.DD.YYYY, YYYY/MM/DD,
YYYY/DD/MM, DD/MM/YYYY, MM/DD/YYYY, YYYY-MM-DD, YYYY-DD-
MM, DD-MM-YYYY, MM-DD-YYYY.