68
26.2. Local Settings
In order to access local settings, press operation panel key to which
<
Working mode parameters> pictogram is assigned:
Readout For detailed description read section 25.1.
Proximity sensors For detailed description read section 25.2.
Save mode For detailed description read section 25.3.
Auto threshold For detailed description read section 25.4.
Result control For detailed description read section 25.5.
Autotare For detailed description read section 25.6.
Labelling mode For detailed description read section 25.7.
Statistics For detailed description read section 25.8.
27. WORKING MODE – PARTS COUNTING
<Parts counting> is a working mode enabling you to determine quantity
of small pieces of the same mass, which determination is done on the basis
of reference weight value of a single piece, either determined using the
weighing device or taken form the database.
27.1. Home Screen
27.2. Local Settings
In order to access local settings, press operation panel key to which
<
Working mode parameters> pictogram is assigned:
To Next Page
Loading...
