RADWAG PUE C32

83
When
1. You declare low deviation of value greater than the declared ingredient
mass then the following message is displayed: <Value too high>; enter
correct low deviation value.
2. You declare high deviation of value greater than the declared ingredient
mass then the following message is displayed: <Value too high>; enter
correct high deviation value.
• Enter the required data and press button, the new ingredient is
added to the formulation.
• Enter the last ingredient and go to the home screen, do it by pressing
key.
30.4. Formulation Procedure
• Select the formulation, do it by pressing the key to which pictogram
(select formulation) is assigned.
• Save general parameters of 'Dosing' mode to the scale memory,
the parameters are to be found upon pressing a key to which
pictogram is assigned.
• Press the key to which
pictogram (process start) is assigned.
When:
1. The declared value of formulation multiplier causes exceeding of the max
capacity value, then the following message is displayed: <Formulation
multiplier value too high>. The process gets cancelled.
2. The declared value of ingredient mass exceeds the max capacity value,
then the following message is displayed: <Ingredient mass value higher
than max capacity value>. The process gets cancelled.
3. Sum of ingredient mass and high deviation values exceeds the max
capacity value, then the following message is displayed: <High deviation
value too high>. The process gets cancelled.
4. The weighing result is unstable the following message is displayed:
<Unstable weighing result>. The process status changes to PS=Pause
and remains so until stable weighing result is obtained.